■ Example
host1(config-dos-protection)#protocol IpLocalDhcpIc skip-priority-rate-limiter
■ Use the no version to set the value to the default, which is not to use
skip-priority-rate-limiter.
■ See protocol skip-priority-rate-limiter.
protocol weight
■ Use to set the weight for the protocol.
■ For each port compression, weight determines the effective minimum rate that
each protocol receives.
■ Within each port compression, the sum of the minimum rates for all protocols
is equal to or less than the priority rate.
■ For each priority, there is a separate rate for each DoS protection group.
■ Example
host1(config-dos-protection)#protocol IpLocalDhcpIc weight 100
■ Use the no version to set the weight to the value specified in the associated
default group.
■ See protocol weight.
use canned-group
■ Use to create a DoS protection group that uses a pre-programmed set of
parameters.
■ Use the revert keyword to return the values to the canned group values
■ Example
host1#use canned-group group1
■ Use the no version to associate the group with the default canned group settings.
■ See use canned-group.
vlan dos-protection-group
■ Use to attach a VLAN DoS protection group to an interface.
■ Example
host1(config-if)#vlan dos-protection-group
■ Use the no version to remove the attachment of the DoS protection group from
the interface.
■ See vlan dos-protection-group.
Denial of Service (DoS) Protection ■ 471
Chapter 7: Passwords and Security
To Next Page
Loading...