■ Use to create a DoS protection group and enter DoS Protection Group
Configuration mode.
■ A group named default always exists.
■ Example
host1(coonfig)#dos-protection-group default
■ Use the no version to remove the DoS protection group.
■ See dos-protection-group.
ethernet dos-protection-group
■ Use to attach an Ethernet DoS protection group to an interface.
■ Example
host1(config-if)#ethernet dos-protection-group group1
■ Use the no version to remove the attachment of the DoS protection group from
the interface.
■ See ethernet dos-protection-group.
frame-relay dos-protection-group
■ Use to attach a Frame Relay DoS protection group to an interface.
■ Example
host1(config-if)#frame-relay dos-protection-group group1
■ Use the no version to remove the attachment of the DoS protection group from
the interface.
■ See frame-relay dos-protection-group.
hdlc dos-protection-group
■ Use to attach an HDLC DoS protection group to an interface.
■ Example
host1(config-if)#hdlc dos-protection-group group1
■ Use the no version to remove the attachment of the DoS protection group from
the interface.
■ See hdlc dos-protection-group.
ip dos-protection-group
■ Use to attach an IP DoS protection group to an interface.
■ Example 1
host1(config-if)#ip dos-protection-group group1
Denial of Service (DoS) Protection ■ 467
Chapter 7: Passwords and Security
To Next Page
Loading...