Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

■ Example 2
host1(config)#dos-protection-group default
host1(config-dos-protection)#protocol AtmOam rate 512
host1(config-dos-protection)#protocol PppoeControl rate 512
host1(config-dos-protection)#protocol IpLocalOther rate 512
■ Use the no version to remove the attachment of the DoS protection group from
the interface.
■ See ip dos-protection-group.
ipv6 dos-protection-group
■ Use to attach an IPv6 DoS protection group to an interface.
■ Example
host1(config-if)#ipv6 dos-protection-group group1
■ Use the no version to remove the attachment of the DoS protection group from
the interface.
■ See ipv6 dos-protection-group.
lag dos-protection-group
■ Use to attach a LAG DoS protection group to an interface.
■ Example
host1(config-if)#lag dos-protection-group group1
■ Use the no version to remove the attachment of the DoS protection group from
the interface.
■ See lag dos-protection-group.
ppp dos-protection-group
■ Use to attach a PPP DoS protection group to an interface.
■ Example
host1(config-if)#ppp dos-protection-group group1
■ Use the no version to remove the attachment of the DoS protection group from
the interface.
■ See ppp dos-protection-group.
pppoe dos-protection-group
■ Use to attach a PPPoE DoS protection group to an interface.
■ Example
host1(config-if)#pppoe dos-protection-group group1
468 ■ Denial of Service (DoS) Protection
JUNOSe 11.1.x System Basics Configuration Guide