Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

exception Configure core dump
exclude-subsystem Exclude copying a subsystem from the release
exit Exit from the current command mode
ftp-server Configure FTP Server characteristics
help Describe the interactive help system
host Add/modify an entry to the host table
hostname Set the host (system) name
interface Enter Interface Configuration mode
ip Configure IP characteristics
l2tp Configure L2TP parameters
license Configure licenses
line Enter Line Configuration mode
log Configure logging settings
macro Run a CLI macro
map-list Create an NBMA static map
memory Configure and administer memory operations
mpls Configure MPLS global parameters
no Negate a command or set its default(s)
ntp Configure the Network Time Protocol
policy-list Enter Policy Configuration mode
pppoe Configure PPPoE
profile Specify a profile
radius Configure RADIUS server
rate-limit-profile Enter rate limit profile configuration mode
redundancy Perform a redundancy configuration
route-map Configure a route map
router Configure a routing protocol
rtr Configure rtr parameters
run Run an exec mode command (alias command do)
service Configure system-level services
set Configure
sleep Make the Command Interface pause for a specified
duration
slot Configure and administer slot operation
snmp-server Configure SNMP parameters
sscc The SSC Client telnet
telnet telnet daemon configuration
timing Configure network timing
traffic-shape-profile Enter traffic shape profile configuration mode
virtual-router Specify a virtual router
Example 2 host1(config)#ip ?
address-pool Configure address pool for PPP Broadband RAS
clients
as-path Configure a path filter for AS-Paths in BGP
bgp-community Format for BGP community
community-list Configure an entry in a community list
debounce-time Specify the minimum amount of time that an event
needs to be in same state before being reported
dhcp-local The DHCP Local Server protocol
dhcp-server DHCP Server for Proxy Client
domain-lookup Enable DNS lookup
domain-name Specify local Domain name
dvmrp configure dvmrp paramaters
dynamic-interface-prefix Specify name prefix for dynamic Ip shared
interfaces
explicit-path Configure an explicit path
extcommunity-list The extended community list
ftp Configure FTP characteristics
http Configure http server
local Local IP address assignment
Using Help ■ 65
Chapter 2: Command-Line Interface

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English