host1(config-mgmtevent-event)#enable
host1(config-mgmtevent-event)#exit
host1(config-mgmtevent)#
NOTE: Once enabled, you cannot edit an event or trigger configuration. To change
an enabled event or trigger, you must delete it and re-create it.
6. Define the trigger that you want to use for an event by specifying a trigger owner
and trigger name.
host1(config-mgmtevent)#trigger george trigger1
host1(config-mgmtevent-trigger)#
7. Specify a MIB object to sample.
host1(config-mgmtevent-trigger)#sample value-id 1.3.6.1.2.1.60.1.2.1.1.7
8. Specify the frequency (in seconds) at which you want the sampling to occur.
host1(config-mgmtevent-trigger)#frequency 100
NOTE: Unless you specify that you want to perform delta sampling, the values are
absolute.
9. (Optional) Specify that you want to perform delta sampling on the sample value
ID.
host1(config-mgmtevent-trigger)#delta-sampling
■ (Optional) Enter the discontinuity MIB value ID that you want to test.
host1(config-mgmtevent-trigger)#delta-sampling discontinuity-id
1.3.6.1.2.1.31.1.1.1.19.9
■ (Optional) Enter the discontinuity type (timeStamp or timeTicks) that you
want the test to use.
host1(config-mgmtevent-trigger)#delta-sampling discontinuity-id-type
timeStamp
10. (Optional) Configure the desired SNMP security level for the agent that you want
to poll.
host1(config)#snmp security read
11. Define the test values that you want this trigger to use.
You can define a Boolean test, existence test, or threshold test. See the following
sections for procedures.
Configuring the SNMP Server Event Manager ■ 181
Chapter 4: Configuring SNMP
To Next Page
Loading...