host1(config-mgmtevent-trigger)#existence-test startup present
■ Example 3—Specifying an existence test type
host1(config-mgmtevent-trigger)#existence-test test-type absent
■ Use the no version to delete the existence-test values for this trigger or to remove
either the startup condition or event binding.
■ See existence-test.
frequency
■ Use to set the frequency (in seconds) at which you want MIB sampling to occur.
■ Example
host1(config-mgmtevent)#frequency 100
■ Use the no version to restore the default frequency value (600 seconds).
■ See frequency.
notification id
■ Use to specify a trap notification for an event.
■ Example
host1(config-mgmtevent-event)#notification id mteTriggerFailure
■ Use the no version to remove the notification from the event. Removal returns
the notification value to its default (0.0)
■ See notification id.
resource
■ Use to specify the total number of triggers that the virtual router allows.
CAUTION: When assigning wildcards, make sure to allow for enough trigger resources.
■ Example
host1(config-mgmtevent-event)#resource 250
■ Use the no version to restore the default resource value (50).
■ See resource.
sample
■ Use to specify the MIB object that you want to sample for the trigger that you
are configuring.
■ Example
Configuring the SNMP Server Event Manager ■ 187
Chapter 4: Configuring SNMP
To Next Page
Loading...