Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

List of Figures
Part 1 Chapters
Chapter 1 Planning Your Network 3
Figure 1: Private Line Aggregation with the E Series Router ............................5
Figure 2: B-RAS Application .............................................................................6
Figure 3: Network Configuration Using a Bottom-Up Approach .......................7
Figure 4: E Series Router Support for Fractional T1/E1 Through T3/E3
Interfaces ................................................................................................11
Figure 5: Channelized T3 Interface Configuration Parameters .......................13
Figure 6: T3 Interface Configuration Parameters ...........................................14
Figure 7: SONET Interfaces ...........................................................................14
Figure 8: Parameters for T1 over DS3 Interface Configuration ......................15
Figure 9: Frame Relay Interface Design .........................................................17
Figure 10: Structure of Frame Relay Protocols ...............................................18
Figure 11: Serial Interface Configuration Parameters for a Frame Relay
Connection .............................................................................................18
Figure 12: E Series Router IP/ATM Access Connection ...................................19
Figure 13: Structure of the ATM Interface Design ..........................................19
Figure 14: Structure of ATM Protocol .............................................................20
Figure 15: ATM Interface Configuration Parameters ......................................20
Figure 16: IP/PPP Connections from the CPE on an E Series Router ..............21
Figure 17: Structure of PPP ...........................................................................21
Figure 18: PPP Interface Configuration Parameters .......................................21
Figure 19: Structure of Cisco HDLC Protocol .................................................22
Figure 20: Example of IP over Ethernet Stacking Configuration Steps ...........23
Chapter 2 Command-Line Interface 29
Figure 21: Command Mode Architecture .......................................................30
Chapter 5 Managing the System 251
Figure 22: Transferring System Files to the E Series Router .........................301
Figure 23: FTP Configuration Example ........................................................311
Figure 24: DNS Hierarchy Example .............................................................320
Chapter 7 Passwords and Security 417
Figure 25: Location of the Software Reset Button ........................................423
Figure 26: Typical Control Packet Processing ..............................................451
Chapter 10 Configuring the System Clock 521
Figure 27: Example of an NTP Hierarchy ....................................................522
Chapter 11 Configuring Virtual Routers 539
Figure 28: Virtual Routers ............................................................................540
List of Figures ■ xxiii

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English