Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

host1(config)#
■ Example 2
host1#configure
Configuring from terminal or file [terminal]? file
File name: system1.scr
Proceed with configure? [confirm]
host1(config)#
■ There is no no version.
■ See configure.
disable
■ Use to exit Privileged Exec mode and return to User Exec mode.
■ Use to move to a lower Privileged Exec mode level without returning to User
Exec mode. Specifying a privilege level after the disable command changes the
Privileged Exec mode to the lower level that you specify; you do not return to
User Exec mode.
■ Example 1
host1#disable
host1>
■ Example 2
host1#show privilege
Privilege level is 10
host1#disable 5
host1#show privilege
Privilege level is 5
■ There is no no version.
■ See disable.
do
■ Use to issue an Exec mode command from any CLI configuration command
mode.
■ Example
host1(config)#do show configuration | begin interface
■ The do command functions the same as the run command.
■ There is no no version.
■ See do.
enable
256 ■ Using the CLI
JUNOSe 11.1.x System Basics Configuration Guide