host1(config)#service password-encryption
host1(config)#host test 10.2.3.4 ftp nick nick
host1(config)#end
host1#show config | inc host
hostname "host1"
host test 10.2.3.4 ftp 8 CU&l,XM(S 8 X=emZn>'S
■ Use the no version to remove a specified host.
■ See host.
ip ftp source-address
■ Use to specify an operational interface by IP address as the source interface for
FTP packets sent by the system’s FTP client.
■ This command overrides a setting you configured previously with the ip ftp
source-interface command.
■ If you issue this command, the output of the show configuration command
includes an entry of the following format:
ip ftp source-address ipAddress
This entry also appears in the output if you delete an interface or change its IP
address after issuing the ip ftp source-interface command, in which case the
IP address is the one that was configured on the interface before you issued the
ip ftp source-interface command.
■ Example
host1(config)#ip ftp source-address 10.10.5.21
■ Use the no version to restore the default, in which the source address in the FTP
packets is that of the interface where the FTP connection is made.
■ See ip ftp source-address.
ip ftp source-interface
■ Use to specify an operational interface by interface type and location as the
source interface for FTP packets sent by the system’s FTP client.
■ The interface you specify must have an IP address.
■ This command overrides a setting you configured previously with the ip ftp
source-address command.
■ If you issue this command and the interface is valid, the output of the show
configuration command includes an entry of the following format:
ip ftp source-interface interfaceType interfaceSpecifier
■ interfaceType—Type of interface
■ interfaceSpecifier—Location of the interface
For information about interface types and specifiers, see Interface Types
and Specifiers in JUNOSe Command Reference Guide.
306 ■ Transferring Files
JUNOSe 11.1.x System Basics Configuration Guide
To Next Page
Loading...