Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

■ Resource Threshold Trap—Status (enabled or disabled) of the resource
threshold trap
■ type—Interface type
■ location—Location of the interface (system or slot location)
■ max capacity—Maximum capacity of the interface at either the system or
slot level
■ current value—Current capacity of the interface at either the system or slot
level
■ rising threshold—Rising threshold setting for the interface at either the system
or slot level
■ falling threshold—Falling threshold setting for the interface at either the
system or slot level
■ hold-down time—Hold-down time setting for the interface at either the
system or slot level
■ Example 1
host1#show resource
Resource Threshold Trap: enabled
max current rising
type location capacity value threshold
--------------------------- -------- -------- ------- ---------
ip interface system 32000 1 28800
ip interface slot 3 8192 0 7373
ip interface slot 4 4095 0 3686
atm-sub-if interface system 65536 0 58982
atm-vc interface system 65536 0 58982
ppp-link interface system 32768 0 29491
ppp-link interface slot 3 2048 0 1843
ppp-link interface slot 4 6 0 5
atm-active-sub-if interface system 65536 0 58982
falling hold-down
type location threshold time
--------------------------- -------- --------- ---------
ip interface system 320 300
ip interface slot 3 82 300
ip interface slot 4 41 300
atm-sub-if interface system 655 300
atm-vc interface system 655 300
ppp-link interface system 328 300
ppp-link interface slot 3 20 300
ppp-link interface slot 4 0 300
atm-active-sub-if interface system 655 300
■ Example 2
host1#show resource threshold trap
Resource Threshold Trap: enabled
■ See show resource.
336 ■ Managing and Monitoring Resources
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English