with it. To disable a specific IOA on the E120 or E320 Router, issue “adapter
disable” on page 362 command.
■ Example 1—Disables the module in slot 3
host1(config)#slot disable 3
■ Example 2—Disables the SRP module and the SC subsystem in slot 7 (applies
only to the E120 and E320 routers)
host1(config)#slot disable 7
■ Example 3—Disables only the fabric slice on the SRP module in slot 7 (applies
only to E120 and E320 routers)
host1(config)#slot disable 7 fabric
■ There is no no version.
■ See slot disable.
slot enable
■ Use to enable the module in the specified slot.
■ Allows you to restart the module that was installed in the slot.
■ You cannot use this command on a standby SRP module.
■ If you specify a slot on the E120 or E320 Broadband Services Routers that
contains an SRP module, you enable the SC subsystem on that slot by default.
You do not, however, enable the fabric slice that resides on the slot.
■ Use the srp keyword to enable only the portion of the SC subsystem that
resides on a specified SRP module.
■ Use the fabric keyword to enable only the fabric slice that resides on the
specified SRP module.
■ If you specify a slot that contains a line module, you enable only the line module;
you do not enable the line module and the I/O modules and IOAs associated
with it. To enable a specific IOA on the E120 or E320 Broadband Services Routers,
use “adapter enable” on page 362 command.
■ The default is enable.
■ Example 1—Enables the module in slot 3
host1(config)#slot enable 3
■ Example 2—Enables the SRP module and the SC subsystem in slot 7 (applies
only to E120 and E320 routers)
host1(config)#slot enable 7
■ Example 3—Enables only the fabric slice on the SRP module in slot 7 (applies
only to E120 and E320 routers)
host1(config)#slot enable 7 fabric
Disabling and Reenabling Line Modules, SRP Modules, and SFMs ■ 361
Chapter 6: Managing Modules
To Next Page
Loading...
Need help?
General
