EasyManua.ls Logo

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
640 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Adapters
--------
number
of
serial assembly assembly MAC
slot type number number rev. addresses
---- -------- ---------- ---------- -------- ---------
0/0 --- --- --- --- ---
0/1 --- --- --- --- ---
1/0 --- --- --- --- ---
1/1 GE-8 IOA 4306472048 4500009102 A04 8
2/0 --- --- --- --- ---
2/1 GE-8 IOA 4306362247 4500009102 A03 8
3/0 --- --- --- --- ---
3/1 --- --- --- --- ---
4/0 --- --- --- --- ---
4/1 --- --- --- --- ---
5/0 --- --- --- --- ---
5/1 --- --- --- --- ---
6/0 SRP IOA 4306483232 4501006502 A00 2
base Major/Minor
slot MAC address rev
---- -------------- -----------
0/0 --- ---
0/1 --- ---
1/0 --- ---
1/1 0090.1a42.7327 2.4
2/0 --- ---
2/1 0090.1a42.5223 2.3
3/0 --- ---
3/1 --- ---
4/0 --- ---
4/1 --- ---
5/0 --- ---
5/1 --- ---
6/0 0090.1a42.76c4 2.0
Fan(s)
------
serial assembly assembly Major/Minor
Tray type number number rev. rev
---- ----------- ---------- ---------- -------- -----------
0 Primary FAN 4306505285 4400010001 01 1.101
See show hardware.
show utilization
Use to display information about the resources that modules consume.
When you issue this command, the router releases available memory on the
SRP module immediately; however, the display appears a few seconds later.
To display detailed information about the average CPU utilization percentage
calculated over 5-second, 1-minute, and 5-minute intervals for each module
installed in the router, use the detail keyword.
Field descriptions
412 Monitoring Modules
JUNOSe 11.1.x System Basics Configuration Guide

Table of Contents

Related product manuals