EasyManua.ls Logo

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
640 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IP Local Dhcp (IC) OK 0
IP Local Icmp Echo OK 0
IP Local Icmp Other OK 0
IP Local LDP OK 0
IP Local BGP OK 0
IP Local OSPF OK 0
IP Local RSVP OK 0
IP Local PIM OK 0
IP Local COPS OK 0
IP Local L2tp Control (SC) OK 0
IP Local L2tp Control (IC) OK 0
IP Local Other OK 0
IP Local Subscriber Interface Miss OK 0
IP Route To SRP Ethernet OK 0
IP Route No Route Exists OK 0
IP Normal Path MTU OK 0
IP Neighbor Discovery OK 0
IP Neighbor Discovery Miss OK 0
IP Search Error OK 0
IP MLD OK 0
IP Local PIM Assert OK 0
IP Local BFD OK 0
IP IKE OK 0
IP Reassembly OK 0
IP Local Icmp Frag OK 0
IP Local Frag OK 0
IP Application Classifier HTTP Redirect OK 0
Priority Information
Priority State Transitions
------------ ---------- -----------
Hi-Green-IC OK 0
Hi-Yellow-IC OK 0
Lo-Green-IC OK 0
Lo-Yellow-IC OK 1
Hi-Green-SC OK 0
Hi-Yellow-SC OK 0
Lo-Green-SC OK 0
Lo-Yellow-SC OK 0
See show suspicious-control-flow-detection info.
show suspicious-control-flow-detection protocol
Use to display protocol information for suspicious control flows.
Field descriptions
ProtocolControl protocol
ThresholdThreshold in packets per second
Lo-ThresholdLow threshold in packets per second
Backoff-TimeBackoff time in seconds
Example
host1(config)#show suspicious-control-flow-detection protocol
Protocol Threshold Lo-Threshold Backoff-Time
------------------------------ --------- ------------ ------------
Denial of Service (DoS) Protection 459
Chapter 7: Passwords and Security

Table of Contents

Related product manuals