set Configure
sleep Make the Command Interface pause for a
specified duration
slot Configure and administer slot operation
snmp-server Configure SNMP parameters
sscc The SSC Client
telnet telnet daemon configuration
timing Configure network timing
traffic-shape-profile Enter traffic shape profile configuration mode
virtual-router Specify a virtual router
host1:western:eastern(config)#
■ View the VRF configuration choices from VRF Configuration mode.
host1:western(config-vrf)#?
exit Exit from the current command mode
export Specify VRF export characteristics
help Describe the interactive help system
import Specify VRF import characteristics
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
rd Specify route distinguisher
route-target Specify VPN extended community Target
sleep Make the Command Interface pause for a
specified duration
host1:western(config-vrf)#
■ Access a VR to configure it with an interior gateway protocol (IGP) or exterior
gateway protocol (EGP) to learn routes from a customer edge (CE) device. See
the related routing protocol chapters for detailed information.
Example 1
VR with an IGP
host1(config)#virtual-router miami
host1:miami(config)#router ospf 5
host1:miami(config-router)#
Example 2
VR with an EGP
host1(config)#virtual-router western
host1:western(config)#router bgp 359
host1:western(config-router)#
■ Configure a Telnet daemon to listen in VRs other than the default VR.
host1(config)#virtual-router boston
host1:boston(config)#telnet listen port 23
■ List all VRs and VRFs on the router.
host1#show virtual-router
Virtual Router : default
Virtual Router : thursday
Virtual Router : western
VRF : eastern
Virtual Router : boston
Virtual Router : miami
Virtual Router : northern
Configuring Virtual Routers ■ 543
Chapter 11: Configuring Virtual Routers
To Next Page
Loading...