EasyManua.ls Logo

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X - Page 626

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
640 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
bandwidth oversubscription
configuring..........................................................376
monitoring..........................................................376
overview.............................................................373
bandwidth oversubscription command......................376
banner command......................................................285
banners
configuring..........................................................285
baseline commands
baseline show-delta-counts.................................337
baseline snmp....................................................239
BGP (Border Gateway Protocol)....................................24
blowfish-cbc encryption algorithm for SSH................437
boot commands
boot backup........................................................509
boot config..........................................................511
boot config factory-defaults.................................511
boot config once.................................................511
boot config running-configuration.......................511
boot config startup-configuration........................511
boot force-backup...............................................511
boot hotfix..........................................................392
boot revert-tolerance...........................................511
boot revert-tolerance never.................................511
boot subsystem...................................................511
boot system........................................................511
Boot mode.........................................................384, 387
accessing............................................................137
software installation............................................137
booting the system............................130, 135, 138, 509
rebooting............................................................514
while running scripts or macros..........................517
Border Gateway Protocol. See BGP
bottom-up approach to network configuration...............6
bridge commands
bridge subscriber-policy........................................88
broadcasts, NTP.........................................................530
bulk statistics, SNMP
collecting....................................................195, 237
configuring
collectors and receivers...............................195
schemas......................................................215
formatter............................................................237
if-stats objects.....................................................215
mapping to MIBs and CLI....................................223
monitoring
collection statistics.......................................200
schema statistics..........................................235
bulkstats commands..................................................200
bulkstats collector.......................................179, 200
bulkstats collector collect-mode..........................200
bulkstats collector description.............................200
bulkstats collector interval..................................200
bulkstats collector max-size................................200
bulkstats collector primary-receiver....................200
bulkstats collector secondary-receiver.................200
bulkstats collector single-interval........................200
bulkstats file-format endOfLine-Lf.......................237
bulkstats interface-type.......................................200
bulkstats interfaces description-format
common.........................................................200
bulkstats receiver remote-name..........................200
bulkstats schema................................................215
bulkstats schema subtree....................................215
bulkstats schema subtree policy..........................215
bulkstats traps....................................................200
bulkstats virtual-router-group..............................200
See also show bulkstats commands
C
caching, configuration................................................517
capitalization. See case sensitivity
case sensitivity.............................................................67
channelized E1 interfaces
configuring............................................................15
channelized T1 interfaces
configuring............................................................14
channelized T3 interfaces
configuring............................................................12
line rates...............................................................10
characters on terminal screen, setting bits for............283
Classifier Group Configuration mode......................71, 91
clear commands
clear line.............................................................261
CLI (command-line interface).....................................255
abbreviating keywords....................................30, 67
accessing..............................................................48
command modes. See command modes
context-sensitive help...................................63, 255
editing keys..........................................................67
editing on.............................................................67
logging in..............................................................48
pausing...............................................................255
system prompts....................................................43
CLI access levels, VSA descriptions....................447, 448
CLI command execution by macro file.......................473
CLI messages
configuring..........................................................285
CLI status indicator......................................................43
client, SNMP..............................................................148
configuring access.......................................159, 160
clock..........................................................................525
clock commands........................................................525
clock set..............................................................525
clock summer-time date.....................................525
clock summer-time recurring..............................525
clock timezone....................................................525
cOCx/STMx interfaces
line rates...............................................................10
coldStart, SNMP trap..................................................168
Color Mark Profile Configuration mode..................71, 91
596 Index
JUNOSe 11.1.x System Basics Configuration Guide

Table of Contents

Related product manuals