Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

radius relay commands
radius relay accounting server..............................88
radius relay authentication server.........................88
RADIUS Relay Configuration mode..............................81
Rate Limit Profile Configuration mode.................81, 114
rate limiting
per priority.........................................................451
per protocol........................................................451
reachability, tracking..................................................332
reaching an FTP server. See FTP access
reboot history (reboot.hty) file...................................290
reboot history, displaying...........................................345
rebooting the system.........................................509, 517
See also booting the system
redistribute routes........................................................25
Redundancy Configuration mode.........................81, 115
references
draft RFCs...........................................................584
hardware standards............................................590
non-RFC software standards...............................587
RFCs...................................................................571
refusing NTP broadcasts.............................................530
regular expressions................................................37, 41
metacharacters.....................................................41
specifying as literals.......................................41
releasing available memory.......................................290
reload commands
reload.........................................................325, 514
reload at.............................................................514
reload in.............................................................514
reload slot...........................................................514
Remote Authentication Dial-In User Service. See
RADIUS
remote host command...............................................103
Remote Neighbor Configuration mode.................81, 115
remote-neighbor command.......................................115
rename command.....................................................293
renaming files............................................................293
replies, NTP...............................................................527
reset button, software................................................424
resetting while running scripts or macros..................517
resource commands
resource if-type...................................................335
resource threshold..............................................335
resources
monitoring..........................................................412
revisions, displaying assembly...................................517
RFC 1213 interface numbering..................................236
RFCs..........................................................................571
draft....................................................................584
Right Arrow key...........................................................67
RIP (Routing Information Protocol)..............................24
Route Map Configuration mode...........................82, 116
route maps...................................................................25
route-map command.................................................116
router commands
router....................................................................88
router bgp.............................................................88
router ospf............................................................88
router pim............................................................88
router rip..............................................................88
Router Configuration mode..................................82, 116
routers. See system
Routing Information Protocol. See RIP
routing policy
configuring............................................................25
routing protocols..........................................................24
configuring............................................................24
routing, IP
configuring other protocols...................................24
monitoring..........................................................545
RSVP Configuration mode....................................82, 117
rtr commands
rtr.........................................................................88
RTR Configuration mode......................................82, 117
run command......................................................35, 255
S
schedule-profile command.........................................118
Scheduler Profile Configuration mode..................82, 118
screen. See terminal
script files..................................................................291
scripts
resetting system while running...........................517
secondary NTP servers...............................................521
secure IP tunnels..........................................................16
Secure Shell Server protocol. See SSH
security
administration through SSH instead of
Telnet..............................................................435
SSH issues...........................................................437
security features of SNMP..........................................148
send command..........................................................289
sending messages to terminals..................................288
serial numbers, displaying for hardware....................517
servers, NTP...............................................................522
service commands
service..................................................................88
service ctrl-x-reboot......................................68, 514
service manual-commit.......................................277
service password-encryption.......................418, 420
service unattended password-recovery...............423
Service Manager commands
service-management service-session-profile.........88
Service Session Profile Configuration mode.........83, 118
Set operation, SNMP..................................................156
SetRequest PDU type, SNMP......................................156
SFMs (switch fabric modules)
accepting configurations.....................................370
disabling.....................................................360, 404
604 ■ Index
JUNOSe 11.1.x System Basics Configuration Guide