Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

The only commands that cannot be preceded by run or do are the configure
command and those commands that are already available in all modes, such as sleep
or exit.
Example 1 host1(config)#run show config | begin interface
interface null 0
!
interface fastEthernet 0/0
ip address 10.6.129.41 255.255.128.0
!
interface gigabitEthernet 5/0
!
interface atm 6/0
interface atm 6/0.1 point-to-point
encapsulation pppoe
!
interface atm 6/0.1.7
!
interface atm 6/0.1.5
!
interface atm 6/0.1.2
!
interface atm 6/0.1.9
!
interface atm 6/0.1.11
!
interface atm 6/0.1.15
!
interface atm 6/0.1.18
!
ip route 0.0.0.0 0.0.0.0 10.6.128.1
ip route 10.10.121.72 255.255.255.255 10.6.128.1
!
!
route-map adsf permit 10
router dvmrp
!
router igmp
!
snmp-server community private view everything rw
snmp-server contact Mary
snmp-server
!
! End of generated configuration script.
host 1(config)#int fa 0/0
Example 2 host1(config-if)#do dir
Please wait...
unshared in
file size size date (UTC) use
------------------ -------- -------- ------------------- ---
reboot.hty 31040 31040 10/30/2001 15:31:10
system.log 20481 20481 10/26/2001 17:24:16
soft_clear_in.mac 8578 8578 10/24/2001 14:39:02
erx_3-3-1.rel 71082105 71082105 10/25/2001 13:02:50 !
erx_3-3-1.rel 70502991 70502991 10/24/2001 19:58:08
autocfg.scr 355 355 09/28/2001 13:33:04
Capacity = 224133120, Bytes Free = 44986177, Reserved = 36700160
host1(config-if)#
36 ■ Overview
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English