Keysight U8903B - AES3;SPDIF Output Configuration (Digital Generator); Figure 3-70 Digital Generator > AES Config Menu; Table 3-40 Digital Generator > AES Config Menu Description

Audio Generator Functions 3
Keysight U8903B User’s Guide 159
AES3/SPDIF Output Configuration (Digital Generator)
The AES3/SPDIF output configuration for the digital generator is displayed as shown in
Figure 3-70.
Figure 3-70 Digital Generator > AES Config menu page 1
Table 3-40 Digital Generator > AES Config menu description
Menu Description
Level Press the Level softkey to set the output voltage level.
Resolution
Press the Resolution softkey to set the audio resolution value.
–8 to 24
Valid ity Bit
Press the Validity Bit softkey to select the vailidty bit.
–Set
–Clear
Mode
Press the Mode softkey to select the AES3/SPDIF format.
–Consumer
– Professional
Status Bits
Press the Status Bits softkey to select the status bits type.
– Channel
–User
Edit Bits
Press the Edit Bits softkey to configure the bits according to the format selected. Refer to “Ed it Bits (Consumer
format)” on page 160 and “Ed it Bits (Professional format)” on page 165 for more information.
Clear Bits Press the Clear Bits softkey to clear all the bits.
Save File
Press the Save File softkey to save the bits to a file. Refer to “Save” on page 94 for more information on the Save
menu page.
Load File
Press the Load File softkey to load the bits from a file. Refer to “Recall” on page 95 for more information on the Recall
menu page.