Keysight U8903B - Table A-22 Measurement Settings > SMPTE IMD Menu Tree Description

A Appendixes
514 Keysight U8903B User’s Guide
SMPTE IMD
Table A-22 Measurement settings > SMPTE IMD menu tree description
Tab Level 1 Level 2 Level 3 Description
SMPTE IMD
(Signal Generation)
Waveform
– SMPTE 1:1
– SMPTE 4:1
– SMPTE 10:1
Select the waveform type.
Output Select the output channel.
Waveform Config
Track 1st Ch
–Enable
– Disable
Enable or disable the tracking of the first channel.
Upper Freq Set the upper frequency value.
Lower Freq Set the lower frequency value.
Amplitude Set the amplitude value.
DC Offset Set the DC offset value.
SMPTE IMD
(Signal Analysis)
Freq Lock
Gen Lock
Custom
Select the searching method for the upper and
lower frequencies.
Upper Freq
Set the upper fundamental frequency value.
This setting is only available when Freq Lock is set
to Custom.
Lower Freq
Set the lower fundamental frequency value.
This setting is only available when Freq Lock is set
to Custom.
Sample Size
– 2048
– 4096
– 8192
– 16384
– 32768
– 65536
– 131072
– 262144
– 524288
–1M
–2M
Select the number of samples to be acquired for
the measurement.
Input Range
Auto Range
–On
–Off
Enable or disable the auto input range.
Track 1st Ch
–Enable
– Disable
Enable or disable the tracking of the first channel.
Voltage Range Set the input voltage range.
SMPTE Ratio
Refer to “Bar chart” on page 548 for the bar
chart menu tree.