Keysight U8903B - Sweep Channels; Table 6-3 Sweep Parameter > Channels Menu Description

6 Sweep Function
284 Keysight U8903B User’s Guide
Sweep channels
Figure 6-4 Sweep Parameter > Channels menu page
Points
Press the Points softkey to set the sweep points value. Adjusting the sweep points value will change the sweep step value.
This setting is only available when the sweep spacing is Log or Linear.
Edit Points
Press the Edit Points softkey to configure the sweep points.
Refer to “Edit Points” on page 289 for more information. If the sweep points are changed, the sweep spacing mode will
be set to Custom.
Table 6-2 Sweep Parameter > Points Settings menu description (continued)
Menu Description
NOTE
This setting is only available when the legacy sweep is disabled.
Table 6-3 Sweep Parameter > Channels menu description
Menu Description
Source Press the Source softkey to select the source channel(s).
Measure
Press the Measure softkey to select the measure channel(s). The available selection depends on the number of installed
analog analyzer cards.