7 Test Sequence Application
298 Keysight U8903B User’s Guide
IO Configuration
The IO Configuration tab allows you to configure the output and input settings. There will
be one IO Configuration tab in each test sequence. The settings configured in the IO
configuration will be applied to all the measurements in the test sequence. The TSA >
Project > Test > IO Configuration menu page is displayed as shown in Figure 7-6.
Figure 7-6 TSA > Project > Test > IO Configuration menu page
Table 7-5 TSA > Project > Test > IO Configuration menu description
Menu Description
Add Measurement
Press the Add Measurement softkey to add measurements to the selected test sequence. Refer to “Measurements” on
page 310 for more information.
Edit
Press the Edit softkey to paste a copied measurement after the IO configuration. The IO Configuration cannot be moved or
copied.
Settings Press the Settings softkey to configure the IO settings. Refer to “Settings” on page 299 for more information.
Properties
Press the Properties softkey to configure the IO configuration properties. Refer to “Properties” on page 306 for more
information.
To Next Page
Loading...
