Keysight U8903B - Table 7-32 DFD IMD > Signal Generation Settings Menu Description

Test Sequence Application 7
Keysight U8903B User’s Guide 341
Signal analysis
The DFD IMD signal analysis settings menu page is displayed as shown in Figure 7-34.
Figure 7-34 DFD IMD > Signal Analysis settings menu page
Table 7-32 DFD IMD > Signal Generation settings menu description
Menu Description
Waveform
Press the Waveform softkey to select the waveform type.
– IEC60118
– IEC60268
Output Press the Output softkey to select the output channel.
Waveform Config
Press the Waveform Config softkey to set the waveform configuration. The available settings depend on the waveform
type.
– Track 1st Ch
If Track 1st Ch is enabled, the generator channel 1 waveform configuration settings will be copied to the other channels
and the waveform configuration settings for the other channels cannot be edited. Any changes made to channel 1
waveform configuration settings will be reproduced in the other channels waveform configuration settings. Disable the
Track 1st Ch to set the individual channels.
– Upper Freq
Set the upper frequency value.
– Center Freq
Set the center frequency value.
– Diff Freq
Set the difference frequency value.
–Amplitude
Set the amplitude value.
–DC Offset
Set the DC offset value.