Keysight U8903B - Table A-35 Measurement Settings > Measurement Recorder Menu Tree Description

Appendixes A
Keysight U8903B User’s Guide 543
Measurement recorder
Table A-35 Measurement settings > Measurement Recorder menu tree description
Tab Level 1 Level 2 Level 3 Description
Measurement
Recorder
(Signal Generation)
Waveform
–Sine
– Variable Phase
– Square
– Arbitrary
Select the waveform type.
Output Select the output channel.
Waveform Config
Track 1st Ch
–Enable
– Disable
Enable or disable the tracking of the first channel.
Frequency Set the frequency value.
Amplitude Set the amplitude value.
DC Offset Set the DC offset value.
Measurement
Recorder
(Signal Analysis)
Duration Set the length of the measurement record,
Ref Channel Set the reference channel number.
Wrap Phase
–On
–Off
Enable or disable the wrap phase.
Freq Lock
–Auto
– Gen Lock
– Custom
Select the searching method for the fundamental
frequency.
Fund Freq
Set the fundamental frequency value.
This setting is only available when Freq Lock is set
to Custom.
LPF
–None
–2 kHz
–3 kHz
–5 kHz
–8 kHz
–10 kHz
–15 kHz
–20 kHz
–22 kHz
–30 kHz
–40 kHz
–50 kHz
–80 kHz
– Custom
Select the low-pass filter.