5Graph Analysis
266 Keysight U8903B User’s Guide
Trace Settings
The trace settings for graph analysis is displayed as shown in Figure 5-4.
Figure 5-4 Graph Analysis > Trace Settings menu page 1
Table 5-4 Graph Analysis > Trace Settings menu description
Menu Description
Active Trace Press the Active Trace softkey to select the active trace number.
Source Press the Source softkey to select data source of the active trace from the available channels, traces, files, and memory.
Enabled
Press the Enabled softkey to enable or disable the active trace data. You can also access this function by pressing the Shift
key and the trace number key on the CHANNEL/DATA panel.
Memory Press the Memory softkey to save or load a trace. Refer to “Memory” on page 268 for more information.
Math Press the Math softkey to apply a math function. Refer to “Math” on page 269 for more information.
Unit
Press the Unit softkey to select the trace unit type.
–V
–dBV
–dBu
–W
–dBm
–dBSPL
Persistence
Press the Persistence softkey to configure the persistence settings. Refer to “Persistence” on page 270 for more
information.
To Next Page
Loading...
