Test Sequence Application 7
Keysight U8903B User’s Guide 295
Project
The TSA > Project menu page is displayed as shown in Figure 7-3.
Figure 7-3 TSA > Project menu page
Press the up or down arrow key to select the test sequence, IO configuration, or
measurements tabs. The respective menu page will be displayed. Refer to “Test Sequence”
on page 297, “IO Configuration” on page 298, and “Measurements” on page 310 for more
information.
Table 7-2 TSA > Project menu description
Menu Description
New Project Press the New Project softkey to create a new project.
Open Project
Press the Open Project softkey to load a project from a file. Refer to “Recall” on page 95 for more information on the
Recall menu page.
Save Project
Press the Save Project softkey to save the project to a file. Refer to “Save” on page 94 for more information on the Save
menu page.
Properties
Press the Properties softkey to configure the project properties. Refer to “Properties” on page 296 for more information
on the Properties menu page.
To Next Page
Loading...
