Sweep Function 6
Keysight U8903B User’s Guide 289
Edit Points
Figure 6-8 Sweep > Edit Points menu page 1
Table 6-7 Sweep > Edit Points menu description
Menu Description
Data Channel
Press the Data Channel softkey to select the trace data channel number to be plotted.
This setting is only available when the measured channels are more than one channel.
Wrap Phase
Press the Wrap Phase softkey to enable or disable the wrap phase. This is only applicable if Y Data or Y2 Data is set to
phase.
–On
The phase result is wrapped so that it falls within the range of -180° ~ 180°.
–Off
The result displayed is the exact value after substracted from the reference channel.
Goto Point
Press the Goto Point softkey to set the sweep point number to go to. The sweep point number will be highlighted. You can
also use the arrow keys to select the desired sweep point.
Point Value Press the Point Value softkey to set the currently selected sweep point value.
Add Point Press the Add Point softkey to add a sweep point.
Remove Point Press the Remove Point softkey to remove the selected sweep point.
Load Points
Press the Load Points softkey to load the sweep points from a file.
Refer to “Recall” on page 95 for the Recall menu page.
Save Points
Press the Save Points softkey to save the sweep points to a file.
Refer to “Save” on page 94 for the Save menu page.
If the sweep points are changed, the sweep spacing mode will be set to Custom. Refer to
Table 6-2 for more information.
To Next Page
Loading...
