6 Sweep Function
288 Keysight U8903B User’s Guide
Wrap Phase
Press the Wrap Phase softkey to enable or disable the wrap phase. This is only applicable if Y Data or Y2 Data is set to
phase.
–On
The phase result is wrapped so that it falls within the range of -180° ~ 180°.
–Off
The result displayed is the exact value after substracted from the reference channel.
Hold Type
Press the Hold Type softkey to select the data type to be plotted in the graph.
–None
Initial sweep data.
–Average
Each point is averaged with the corresponding point from the previous result.
–Max
Always keep the maximum value of each point.
–Min
Always plot the minimum value of each point.
Table 6-6 Sweep > Plot View > Plot Settings menu description (continued)
Menu Description
To Next Page
Loading...
