Audio Generator Functions 3
Keysight U8903B User’s Guide 151
Figure 3-65 Bluetooth Analyzer > Link Config > Common Settings menu page 3
Table 3-35 Bluetooth Analyzer > Link Config > Common Settings menu description
Menu Description
Profile
Press the Profile softkey to select the U8903B’s Bluetooth card profile. There are two sets of profiles available and the
selected profile set will be accessible by the connected Bluetooth device.
– A2DP SRC, HFP AG, AVRCP TRGT
A2DP source, HFP audio gateway, AVRCP target
– A2DP SNK, HFP HF, AVRCP CTRL
A2DP sink, HFP handsfree/headset, AVRCP controller
Friendly Name Press the Friendly Name softkey to set the friendly name of the U8903B’s Bluetooth card.
Device PIN Press the Device PIN softkey to set the passkey for the U8903B’s Bluetooth card.
Device Class
Press the Device Class softkey to select the device class based on the configured profile.
–Auto
When auto is set and the Bluetooth card is configured as a source profile, device class sets to 60020C (smartphone).
When auto is set and the Bluetooth card is configured as a sink profile, device class sets to 240408
(handsfree/headset device).
– Custom
Manually set the device class.
Custom
This is only available if the Device Class is set to Custom.
Press the Custom softkey to set the device class.
SSP Mode
Press the SSP Mode softkey to select the U8903B’s Bluetooth card simple secure pairing (SSP) mode when pairing.
– Just Works
Just works mode is selected when only minimal security is needed. No passkey is required during pairing.
– Man-In-The-Middle
Man-in-the-middle mode is selected when maximum security is needed. A passkey is required during pairing.
Auto Pair
Press the Auto Pair softkey to enable or disable the auto-pairing function of the U8903B’s Bluetooth card with a remote
device.
Discoverable
Press the Discoverable softkey to enable or disable the discoverability function of the U8903B’s Bluetooth card by a
remote device.
To Next Page
Loading...
