Keysight U8903B - RUN CONTROL Panel; Table 2-23 Navigation and CHANNEL;DATA Panels Description

Operation and Features 2
Keysight U8903B User’s Guide 93
RUN CONTROL Panel
The RUN CONTROL panel is used to start or stop signal generation, measurements, and
test sequence operations.
Figure 2-35 RUN CONTROL panel
12
Table 2-23 Navigation and CHANNEL/DATA panels description
Key Description
1 On/Off
Press to start or stop the signal generation or measurements for the selected generator or
analyzer channel respectively.
Press to start or stop the graph generation in the graph analysis mode.
Press to start or stop the sweep in the sweep mode.
Press to start or stop the test sequence in the test sequence application mode.
2 Stop All
Press to stop all generator, sweep, and test sequence operations.