Keysight U8903B - Measurement Settings; Table A-15 Measurement Settings > AC Level Menu Tree Description

Appendixes A
Keysight U8903B User’s Guide 503
Measurement settings
AC level
Table A-15 Measurement settings > AC Level menu tree description
Tab Level 1 Level 2 Level 3 Description
AC Level
(Signal Generation)
Waveform
Sine
Variable Phase
Square
Arbitrary
Select the waveform type.
Output Select the output channel.
Waveform Config
Track 1st Ch
–Enable
– Disable
Enable or disable the tracking of the first channel.
Frequency Set the frequency value.
Amplitude Set the amplitude value.
DC Offset Set the DC offset value.
Phase->1st Ch
Set the phase value. This setting is only available
when channel 2 is selected.
AC Level
(Signal Analysis)
Detector
–RMS
–Pk-Pk
Select the AC level detector type.
LPF
–None
–2 kHz
–3 kHz
–5 kHz
–8 kHz
–10 kHz
–15 kHz
–20 kHz
–22 kHz
–30 kHz
–40 kHz
–50 kHz
–80 kHz
– Custom
Select the low-pass filter.