A Appendixes
490 Keysight U8903B User’s Guide
Appendix 11: Sweep Function Menu Tree
Table A-11 Sweep function menu tree description
Level 1 Level 2 Level 3 Level 4 Description
App.Type
–Sweep
– Group Delay
Select the sweep application type.
Parameter
This is only available when the sweep application
type is Sweep.
Select the sweep parameter type.
The parameter selection depends on the
waveform type set at the analog generator.
Points Settings
Spacing
–Log
– Linear
– Custom
Select the spacing type.
Unit
– Vrms
–dBV
–Vp
–Vpp
–dBm
–dBu
–dBSPL
Select the sweep unit.
This setting is only available when the sweep
parameter is amplitude.
Start
Set the sweep start value. This setting is only
available when the sweep spacing is Log or
Linear.
Stop
Set the sweep stop value. This setting is only
available when the sweep spacing is Log or
Linear.
Step
Set the sweep step value. This setting is only
available when the sweep spacing is Log or
Linear.
Points
Set the sweep points value. This setting is only
available when the sweep spacing is Log or
Linear.
Edit Points
Refer to “Edit points” on page 492 for the edit
points menu tree.
Dwell Time
Set the delay in ms for the generator to output the
signal.
Sweep Mode
Continuous
Single
Select the sweep mode.
Channels
Source 1 to 2 Select the source channel(s).
Measure 1 to 8
Select the measure channel(s).
The available selection depends on the number of
installed analog analyzer cards.
To Next Page
Loading...
