Keysight U8903B - Table A-21 Measurement Settings > Crosstalk Menu Tree Description

Appendixes A
Keysight U8903B User’s Guide 513
Crosstalk
Table A-21 Measurement settings > Crosstalk menu tree description
Tab Level 1 Level 2 Level 3 Description
Crosstalk
(Signal Generation)
Waveform
–Sine
– Arbitrary
Select the waveform type.
Output Select the output channel.
Waveform Config
Track 1st Ch
–Enable
– Disable
Enable or disable the tracking of the first channel.
Frequency Set the frequency value.
Amplitude Set the amplitude value.
DC Offset Set the DC offset value.
Crosstalk
(Signal Analysis)
Driven Ch
Select the driven channel number from the
generator.
Freq Lock
–Auto
– Gen Lock
– Custom
Select the searching method for the fundamental
frequency.
Fund Freq
Set the fundamental frequency value.
This setting is only available when Freq Lock is set
to Custom.
Sample Size
–2048
–4096
–8192
– 16384
– 32768
– 65536
– 131072
– 262144
– 524288
–1M
–2M
Select the number of samples to be acquired for
the measurement.
Input Range
Input Range
Auto Range
–On
–Off
Enable or disable the auto input range.
Track 1st Ch
–Enable
– Disable
Enable or disable the tracking of the first channel.
Voltage Range Set the input voltage range.
Crosstalk
Refer to “Bar chart” on page 548 for the bar
chart menu tree.