Sweep Function 6
Keysight U8903B User’s Guide 285
Plot View
The sweep plot view menu page is displayed as shown in Figure 6-5.
Press on the RUN CONTROL panel to start or stop the sweep in the sweep
mode.
Figure 6-5 Sweep > Plot View menu page
Table 6-4 Sweep > Plot View menu description
Menu Description
Axis Settings
Press the Axis Settings softkey to configure the sweep axis settings.
Refer to “Axis settings” on page 286 for more information.
Plot Settings
Press the Plot Settings softkey to configure the sweep trace settings.
Refer to “Plot settings” on page 287 for more information.
Edit Points
Press the Edit Points softkey to configure the sweep points.
Refer to “Ed it Points” on page 289 for more information.
Save Pts
Press the Save Pts softkey to save the sweep points to a file.
Refer to “Save” on page 94 for the Save menu page.
To Next Page
Loading...
