Keysight U8903B - Table 7-33 DFD IMD > Signal Analysis Settings Menu Description

7 Test Sequence Application
342 Keysight U8903B User’s Guide
Table 7-33 DFD IMD > Signal Analysis settings menu description
Menu Description
DFD order
Press the DFD order softkey to select the distortion order to be measured.
–2nd
–3rd
Sample Size
Press the Sample Size softkey to select the number of samples to be acquired for the measurement.
–2048
–4096
–8192
– 16384
– 32768
– 65536
– 131072
– 262144
– 524288
–1M
–2M
Input Range
Press the Input Range softkey to configure the input range settings.
–Auto Range
Enable or disable the auto input range.
If auto range is enabled, each analog channel input range is determined automatically, based on the level of the input
signal. If the input signal level changes beyond the ranging threshold, auto range will cause the input ranging circuits to
move up or down for a proper ranging.
If auto range is disabled, you can set a fixed input voltage range for each analog input channel.
– Track 1st Ch
If Track 1st Ch is enabled, all the other channels will be set to follow the channel 1 range setting. Any changes made to
channel 1 range setting will be reproduced in the other channels. Disable the Track 1st Ch to set the individual
channels.
– Voltage Range
Set the input voltage range.