Keysight U8903B - Measurement Settings; Table 5-9 Graph Analysis > Measurement Menu Description

5Graph Analysis
276 Keysight U8903B User’s Guide
Measurement Settings
The U8903B allows you to observe up to two measurements running simultaneously in the
graph analysis mode. The measurements will be displayed at the bottom of the graph. The
measurement settings for graph analysis is displayed as shown in Figure 5-15.
Figure 5-15 Graph Analysis > Measurement menu page
Table 5-9 Graph Analysis > Measurement menu description
Menu Description
Enabled
Press the Enabled softkey to enable or disable the measurements in the graph. If measurement is not required, disable the
measurements for better performance.
Measurement 1
Press the Measurement 1 softkey to configure the measurement 1 parameters. Refer to “Measurement 1/
Measurement 2” on page 277 for more information.
Measurement 2
Press the Measurement 2 softkey to configure the measurement 2 parameters. Refer to “Measurement 1/
Measurement 2” on page 277 for more information.