Keysight U8903B - Table 7-50 DC Level Sweep > Signal Generation Settings Menu Description

Test Sequence Application 7
Keysight U8903B User’s Guide 377
Signal analysis
The DC level sweep signal analysis settings menu page is displayed as shown in
Figure 7-52.
Figure 7-52 DC Level Sweep > Signal Analysis settings menu page
Table 7-50 DC Level Sweep > Signal Generation settings menu description
Menu Description
Output Press the Output softkey to select the output channel.
Sweep Config
Press the Sweep Config softkey to set the sweep configuration.
–Start
Set the start value for the sweep parameter.
–Stop
Set the stop value for the sweep parameter.
–Spacing
Select Log, Linear, or Custom for the sweep spacing.
–Points
Set the number of sweep points.
–Step Size
Set the step size for linear spacing. This setting is only available when spacing is set to Linear.
–Dwell Time
Set the delay between the sweep points.
– Edit Points
Edit the individual points value, insert or remove points, load points, and save the points.