Keysight U8903B - Measurement; Table 8-2 HP8903 B > Measurement Menu Description

8 HP8903B
410 Keysight U8903B User’s Guide
Measurement
Select Measurement in the HP8903B menu page to configure the HP8903B measurement
settings.
Figure 8-2 HP8903B > Measurement menu page
Table 8-2 HP8903B > Measurement menu description
Menu Description
Function
Press the Function softkey to select the HP8903B measurement mode.
–AC LEVEL
–SINAD
– DISTN
–DC LEVEL
– SIG / NOISE
– DISTN LEVEL
LP Filter
Press the LP Filter softkey to select the HP8903B measurement low-pass filter value. The default low-pass filter can be
set at “HP8903B Config” on page 89.
–None
–30 kHz
–80 kHz
HP/W Filter
Press the HP/W Filter softkey to select the HP8903B high-pass or weighting filter value. The filter selection depends on
the left and right filters set at “HP8903B Config” on page 89.
Reference
Press the Reference softkey to set the reference value to be compared with the measured value in ratio mode. Changing
the reference value will enable the measurement ratio mode.
Ratio Press the Ratio softkey to enable or disable the HP8903B measurement ratio mode.
Format
Press the Format softkey to select the HP8903B measurement format type.
–Log
–Lin