7 Test Sequence Application
358 Keysight U8903B User’s Guide
External frequency sweep
Refer to “Measurement Results” on page 399 for more information on the respective result
menu page. Use the arrow keys to navigate through the respective tabs and to display the
menu page.
Signal generation
The external frequency sweep signal generation settings menu page is displayed as shown
in Figure 7-43.
Figure 7-43 External Frequency Sweep > Signal Generation settings menu page
Table 7-42 External Frequency Sweep > Signal Generation settings menu description
Menu Description
Instrument
Press the Instrument softkey to select the instrument model.
– Keysight 33220A
– Keysight 33250A
– Keysight 33500A
– Keysight 33600A
–Other
GPIB Address
Press the GPIB Address softkey to select the GPIB address.
– 0 to 30
Init Instrument
Press the Init Instrument softkey to enable or disable the U8903B to send SCPI commands to initialize the connected
signal generator.
Init SCPI
Press the Init SCPI softkey to set the SCPI commands that initialize the connected instrument. You can set the SCPI
command directly or load from a file.
–Edit
– Import (Refer to “Recall” on page 95 for more information on the Recall menu page.)
To Next Page
Loading...
