Keysight U8903B - Getting Started; Power on the U8903 B; Preset the U8903 B

1 Getting Started
44 Keysight U8903B User’s Guide
Getting Started
Power on the U8903B
Connect one end of the power cord to the U8903B rear panel AC power inlet and the other
end to an AC voltage source. The U8903B will automatically adjust to the correct line
voltage in the range of 100 VAC to 240 VAC.
Preset the U8903B
A preset will set the U8903B to a default state. It does not affect the I/O configuration,
calibration data, system configurations (time, date, model number, and serial number), and
license information. Refer to “Appendix 19: DSI Input and Output Interface” on page 564
for more information.
To preset the U8903B, you can perform either one of the following steps.
– Send the *RST, SYSTem:PRESet, SYSTem:PRESet:TYPE, or
SYSTem:RESet[:MODE] SCPI command from the PC via the USB, GPIB, or
LAN interface.
– Press on the SYSTEM panel.
NOTE
For more information on preset, refer to “SYSTEM Panel” on page 77.