Keysight U8903B - Appendix 14: Test Sequence Menu Tree; Table A-14 Test Sequence Menu Tree Description

Appendixes A
Keysight U8903B User’s Guide 495
Appendix 14: Test Sequence Menu Tree
Table A-14 Test sequence menu tree description
Tab Level 1 Level 2 Level 3 Description
Project
New Project Create a new project.
Open Project
Load a project from a file.
Refer to “Appendix 13: Recall Menu Tree” on
page 494 for the recall menu tree.
Save Project
Save the project to a file.
Refer to “Appendix 12: Save Menu Tree” on
page 493 for the save menu tree.
Properties
Prompt DUT ID
–On
–Off
Enable or disable the prompt for device ID (device
serial number) at the start of a test sequence.
Prompt Msg
Set the prompt message.
This setting is only available when Prompt DUT ID
is enabled.
Pass/Fail Msg
–On
–Off
Enable or disable the on-screen message dialog
box that can be displayed at the end of a test
sequence. Press Enter to close the dialog box.
Pass Message
Edit the pass message.
This setting is only available when Pass/Fail Msg
is enabled.
Fail Message
Edit the fail message.
This setting is only available when Pass/Fail Msg
is enabled.
Report
Clear Clear all the report data.
Save
Save the report to a DOCX file format.
Refer to “Appendix 12: Save Menu Tree” on
page 493 for the save menu tree.
Properties
Auto Save
–Enable
– Disable
Enable or disable saving the report automatically
at the end of a test sequence.
Format
–Docx
–Html
Select the report file format to be saved.
Name Option
– Timestamp
– Numeric
–Prompt
Select the naming convention of the file name for
the automatically saved report.
Prefix Set the prefix for the file name.
Location
Select
Select the folder for the automatically saved
report.
New Folder
Create a new folder at the current directory or
folder.