Test Sequence Application 7
Keysight U8903B User’s Guide 297
Test Sequence
The TSA > Project > Test menu page is displayed as shown in Figure 7-5.
Figure 7-5 TSA > Project > Test menu page
Table 7-4 TSA > Project > Test menu description
Menu Description
Enable
Press the Enable softkey to enable or disable the selected test sequence. The check boxes for the test and all the
measurements in the test will be selected when enabled.
Add Test Sequence
Press the Add Test Sequence softkey to add a test sequence.
–New
Add a new test sequence.
– Saved
Load a saved test sequence file. Refer to “Recall” on page 95 for more information on the Recall menu page.
Delete Test Sequence Press the Delete Test Sequence softkey to delete the selected test sequence.
Save
Press the Save softkey to save the test sequence to a file. Refer to “Save” on page 94 for more information on the Save
menu page.
Edit
Press the Edit softkey to move or copy the selected test sequence, or paste a copied test sequence after the selected test
sequence.
Properties Press the Properties softkey to set the test sequence name.
To Next Page
Loading...
