Appendixes A
Keysight U8903B User’s Guide 571
Appendix 22: U8903B Configuration Examples
Example 1: Generating a sine waveform with the digital generator and
measuring its voltage with the digital analyzer
In this example, you will learn how to generate a simple sine waveform from the U8903B
digital generator and measure its voltage using the U8903B digital analyzer.
To generate a sine waveform from the digital unbalanced output with a frequency of 1 kHz
and amplitude of 1 FFS, perform the following steps.
1 Connect the digital generator unbalanced output to the digital analyzer unbalanced
input channel in the rear panel using a BNC cable.
2 Press on the FUNCTION panel to switch to audio generator mode, and press
on the FUNCTION panel to switch to digital interface.
3 Press Waveform, and select Sine as the waveform type.
4 Press Output Config > Connector, and select Unbalanced as the digital generator output
type.
5 Press Output Config > AES Output, and enable the AES output.
6 Press Waveform Config > Frequency, and set the frequency to 1 kHz.
7 Press Waveform Config > Amplitude, and set the amplitude to 1 FFS.
8 Press to start the signal generation on the digital generator channel 1.
9 After you have completed the steps above, the U8903B display should look as follows.
Figure A-9 Digital generator sine waveform generation
To Next Page
Loading...
