Keysight U8903B - Table 6-1 Sweep Parameter Menu Description

Sweep Function 6
Keysight U8903B User’s Guide 281
Table 6-1 Sweep Parameter menu description
Menu Description
App. Type
Press the App. Type softkey to select the sweep application type.
–Sweep
– Group Delay
This is only applicable for digital interface. Refer to “Group Delay” on page 282 for more information.
Parameter
This is only available when the sweep application type is Sweep.
Press the Parameter softkey to select the sweep parameter type. The parameter selection depends on the waveform type
set at the analog generator.
Points Settings
Press the Points Settings softkey to configure the sweep point parameters such as start, stop, step size, point count, and
spacing.
Refer to “Points settings” on page 283 for more information.
Dwell Time Press the Dwell Time softkey to set the delay in ms for the generator to output the signal.
Sweep Mode
Press the Sweep Mode softkey to select the sweep mode.
– Continuous
Sweep all points.
–Single
Sweep point by point.
Channels
Press the Channels softkey to set the sweep channels.
Refer to “Sweep channels” on page 284 for more information. This setting is only available when the legacy sweep is
disabled.
Plot View
Press the Plot View softkey to display the Plot View menu page.
Refer to “Plot View” on page 285 for more information.