Keysight U8903B - Appendix 26: U8903 B Default Settings; Analog Generator; Table A-50 Analog Generator Default Settings

Appendixes A
Keysight U8903B User’s Guide 595
Appendix 26: U8903B Default Settings
Analog generator
Table A-50 Analog generator default settings
Level 1 Level 2 Level 3 Default
Waveform Sine
Waveform Config
Amplitude 0 Vrms
Frequency 1 kHz
DC Offset 0 V
Phase -> 1 0°
Frequency 2 2 kHz
Ratio 100%
Lower Feq 60 Hz
Upper Freq
(SMPTE 1:1/4:1/10:1)
7 kHz
Upper Freq (IEC 60118) 10 kHz
Diff Freq 80 Hz
Center Freq 10 kHz
Voltage 0 V
Start Freq 1001.35803222656
Stop Freq 4997.25341796875
Freq Spacing Linear
Tones 2
Length 1024
Dial (DTMF) Mode Single
Amplitude (DTMF) –4.5 dBu
Ratio (DTMF) 2 dB
Tone Duration (DTMF) 90 ms
Tone Delay (DTMF) 90 ms
Pause Time (DTMF) 90 ms
Repeat (DTMF) Off