Keysight U8903B - Properties; Table 7-15 TSA > Project > Test > Measurement > Properties Menu Description

7 Test Sequence Application
312 Keysight U8903B User’s Guide
Properties
An example of the measurement properties menu page is displayed as shown in
Figure 7-16.
Figure 7-16 TSA > Project > Test > AC Level > Properties menu page
Table 7-15 TSA > Project > Test > Measurement > Properties menu description
Menu Description
Name Press the Name softkey to rename the selected measurement.
Sub-Steps
Press the Sub-Steps softkey to configure the sub-steps settings. Refer to “Sub-steps” on page 307 for more information
on the sub-steps settings.
Failure Handling
Press the Failure Handling softkey to select the failure handling type for the selected measurement. When a measurement
exceeded its preset limit or faced failure due to improper configuration (for example, calling for a file that does not exist or
sending a SCPI sub-step to an unconnected devices), you can direct the application to the following:
–Cancel Seq.
Stop the test sequence.
– Allow Retry
Display a prompt window with Abort, Retry, and Ignore commands. Abort will immediately stop the test sequence. Retry
will rerun the selected measurements. Ignore will flag the measurement as failed and continue with the test sequence.
– Continue Seq.
Flag the measurement as failed and continue with the test sequence.