Keysight U8903B - AC Level

Test Sequence Application 7
Keysight U8903B User’s Guide 313
AC level
AC level measurement provides a single value measurement of the output level from each
DUT channel, as measured at each of the analyzer input. The AC level measurement
settings allows you to configure the signal generation and signal analysis settings. The
result for the AC level measurement for all the selected channels are displayed in a bar
chart (AC Level and Gain). The gain result is not available if None is selected for the output
configuration channels. Refer to “Measurement Results” on page 399 for more information
on the respective result menu page.
Use the arrow keys to navigate through the respective tabs and to display the menu page.
Signal generation
The AC level signal generation settings menu page is displayed as shown in Figure 7-17.
Figure 7-17 TSA > Project > Test > AC Level > Settings > Signal Generation menu page
NOTE
The signal generation is disabled if None is selected for the output configuration channel.