Keysight U8903B - Phase

Test Sequence Application 7
Keysight U8903B User’s Guide 319
Phase
Phase measurement provides a single value measurement of the relative phase of the DUT
channels. One channel is chosen as the phase reference channel and the remaining
channels are measured against it. The phase measurement settings allows you to configure
the signal generation settings and signal analysis settings.
The result for the phase measurement for all the selected channels are displayed in a bar
chart (Phase). Refer to “Measurement Results” on page 399 for more information on the
respective result menu page. Use the arrow keys to navigate through the respective tabs
and to display the menu page.
Signal generation
The phase signal generation settings menu page is displayed as shown in Figure 7-21.
Figure 7-21 Phase > Signal Generation settings menu page
NOTE
The signal generation is disabled if None is selected for the output configuration channel.