7 Test Sequence Application
306 Keysight U8903B User’s Guide
Properties
The TSA > Project > Test > IO Configuration > Properties menu page is displayed as shown
in Figure 7-11.
Figure 7-11 Test > IO Configuration > Properties menu page
Table 7-10 TSA > Project > Test > IO Configuration > Properties menu description
Menu Description
Name Press the Name softkey to rename the IO configuration.
Sub-Steps
Press the Sub-Steps softkey to configure the sub-steps settings. Refer to “Sub-steps” on page 307 for more information
on the sub-steps settings.
Failure
Press the Failure softkey to edit the failure message. If one or more measurements in the test sequence fails, the failure
message is displayed. The default message is “Failed”. This setting is only available when Pass/Fail Msg is enabled.
To Next Page
Loading...
