Audio Generator Functions 3
Keysight U8903B User’s Guide 99
Audio Generator
Press on the FUNCTION panel to switch between audio generator or audio analyzer
mode. The Analog Generator menu page, Digital Generator menu page, and Bluetooth
Generator menu page are displayed as shown in Figure 3-1, Figure 3-2, and Figure 3-3
respectively.
Press on the FUNCTION panel to switch between the analog, digital, and Bluetooth
interface.
Press or on the CHANNEL/DATA panel to switch to channel 1 or channel 2
respectively and start configuring the active channel.
Press on the RUN CONTROL panel to start or stop the signal generation for
the selected generator channel.
Figure 3-1 Analog Generator menu page
Table 3-1 Analog Generator menu description
Menu Description
Waveform
Press the Waveform softkey to display the list of available analog generator waveform types. Select the desired waveform
from the drop-down list.
Waveform Config
Press the Waveform Config softkey to set the current active waveform configuration such as frequency, amplitude, and
others. Refer to “Waveform Configuration” on page 102 for more information.
Output Config
Press the Output Config softkey to set the output configurations such as the connector type, impedance, and others. Refer
to “Output Configuration (Analog Generator)” on page 141 for more information.
References
Press the References softkey to configure the output references settings that are used in the unit conversion. Refer to
“References (Analog Generator)” on page 171 for more information.
To Next Page
Loading...
