Keysight U8903B - Sweep Parameter

6 Sweep Function
280 Keysight U8903B User’s Guide
Sweep Parameter
The U8903B sweep mode allows you to perform sweeps and to display the results in a plot
view. Press on the FUNCTION panel to access the sweep mode. The Sweep
Parameter menu page is the default page and is displayed as shown in Figure 6-1.
There are three main panels on the Sweep Parameter menu page. The top panel displays
the current sweep settings and the bottom panels display the audio generator and audio
analyzer settings respectively. Press on the FUNCTION panel to switch between
analog and digital interface. Use the arrow keys to navigate among the panels.
Press on the RUN CONTROL panel to start or stop the sweep in the sweep
mode.
Figure 6-1 Sweep Parameter menu page
NOTE
The U8903B sweep mode is only available in the Standard View mode. Refer to “Menu Key”
on page 60 for more information.